Never Come Back to a Flooded Boat
The Most Reliable Automatic Bilge Protection System
Unlike traditional automatic bilge pumps that rely on float switches, wiring, and permanently installed batteries, Raintaker® uses solid-state water sensing technology with no moving parts to fail.
There are no float switches to stick, no wiring to corrode, and no boat battery to drain. Simply place the unit in your boat and it automatically removes rainwater before it becomes a problem.
Whether your boat is stored at the dock, on a lift, at a marina, or on a trailer, Raintaker provides dependable automatic bilge protection without permanent installation.
Why Traditional Float Switches Fail
The #1 failure point of most automatic bilge pumps is the mechanical float switch.
Over time, float switches can become:
- Stuck in the OFF position, allowing rainwater to accumulate until the boat floods.
- Stuck in the ON position, continuously running the bilge pump and draining the battery.
- Blocked by leaves, dirt, fishing line, debris, or corrosion.
- Damaged by vibration, impact, or normal wear.
Because they rely on moving mechanical parts, float switches become less reliable as they age.
Automatic Bilge Protection, Made Simple
Protect your boat from rainwater with Raintaker®, a portable and self contained bilge protection system designed for reliable automatic water removal without wiring, float switches, or permanent installation.
Solid-State Water Detection
Raintaker uses advanced solid-state capacitive water sensing technology instead of a mechanical float switch.
With no moving parts, the sensor is resistant to:
- Corrosion
- Dirt and debris
- Vibration
- Marine environments
- Normal wear
The result is faster activation, improved long-term reliability, and fewer failure points compared to conventional float switch systems.
No Boat Wiring Required
Traditional automatic bilge pump systems require:
- Marine wiring
- Fuse protection
- Battery connections
- Float switch wiring
- Permanent installation
Every wire connection becomes another possible failure point due to corrosion or vibration.
Raintaker is completely self-contained.
Simply place it in the boat and it begins protecting your vessel automatically.
- No wiring.
- No installation.
- No modifications.
Protect Your Boat Battery
A conventional automatic bilge pump depends entirely on your boat’s battery.
If the float switch sticks ON, the pump can continue running until the battery is completely discharged.
A dead battery can leave you stranded and your bilge pump unable to protect your boat during the next rainstorm.
Raintaker operates from its own rechargeable internal battery, keeping your boat’s starting battery isolated and protected.
Lightweight Protection
Traditional bilge pump systems often require:
- Heavy deep-cycle batteries
- Battery boxes
- Wiring
- Float switches
- Mounting hardware
These components can add 40–70+ pounds to smaller boats.
Raintaker eliminates the need for heavy battery installations while providing fully automatic rainwater removal in one compact portable unit.
Ideal for:
- Dinghies
- RIBs
- Boston Whalers
- Skiffs
- Inflatable boats
- Tenders
- Small center consoles
Built for Real Marine Conditions
Raintaker is designed specifically for harsh marine environments.
Its solid-state activation system resists:
- Saltwater exposure
- Corrosion
- Spray
- Moisture
- Vibration
- Trailering
- Storage
With fewer components and fewer failure points, Raintaker delivers dependable automatic bilge protection season after season.
See what people are saying about the Raintaker®!
⭐⭐⭐⭐⭐
⭐⭐⭐⭐⭐
⭐⭐⭐⭐⭐